Skip to main content

Hacking an analog clock to sync with NTP - Part 1

Inspired by this blog post detailing how to control the ticking mechanism on an analog clock with an Arduino, and having recently come across this gem of a WIFI-enabled micro-controller called ESP8266,  I decided to try and see if I can tether an analog clock to the ESP8266 and make it sync with a time server so that it is always on time (and is able to deal with daylight saving as well).

Not being much of a hardware geek myself, I opted to get the dev board for the ESP8266, the ESP-12E. That way, I can connect it straightaway with my laptop via a USB cable and start coding right away. Cost: ~$6.



Note: What I received turns out to be the ESP-12F, which appears to be virtually identical to ESP-12E.

For the analog clock, I chose to use the $2 RUSCH wall clock from Ikea. Now this is a cheap and nasty clock, made using the cheapest possible material. The second hand doesn't even line up with some of the tick marks as it makes its rounds. But cheap is good for experimentation, and an Ikea clock is useful as a reference point since everyone has access to Ikea.


To be continued...

Labels:

Comments

  1. Fat bloke fat17 July 2022 at 04:12

    I wish you would make this easier to navigate with a 'next in series' button or something.

    ReplyDelete

Post a Comment

Popular posts from this blog

Update: Line adapter for Ozito Blade Trimmer

Update (Dec 2021): If you access to a 3D printer, I would now recommend this solution , which makes it super easy to replace the trimmer line. I have been using it for a few months now with zero issue.
5 comments
Read more

Cooling mod for the X96 Air

I realized after my Ugoos box died that overheating is a big problem with cheap Android TV boxes. A teardown of the Ugoos box shows that it does not have any heatsink or fan at all!  The X96 Air does have a heatsink, but the heatsink is located at the bottom of the casing with no ventilation. In this default configuration, with the ambient room temperature at 25c and playing a 1080p video, I was seeing the CPU temperature at 67c. I drilled a couple of holes at the bottom of the casing. The CPU temperature fell to 59c with the box raised about 2cm with plastic blocks. I retrieved an old 5V laptop fan: Then cut and strip away a spare USB cable: Solder the red and black wires on the fan and the cable: Secure the fan to the bottom of the casing with double-sided tape, then plug the fan into the box's USB connector. Here's a view of the box with some 3D-printed risers installed at the bottom to give the mounted fan sufficient clearance: The CPU now runs at 43c, a huge drop from the ...
2 comments
Read more

Installing and customizing CoreELEC in X96 Air

I previously installed CoreELEC on another TV Box ( Ugoos X3 Pro ), which unfortunately died after only 9 months during the summer (due to the unit overheating, which I learned is a common problem for cheap Android TV boxes). So this time I purchased a X96 Air  (4GB/32Gb) and had to do the whole thing again. So this is a note-to-self in case I ever have to install CoreELEC again on some other device. Installation of CoreELEC is simple enough by following this guide . Basically, it involves downloading and writing the firmware to a microSD card using usbimager . Then insert the microSD card, reset the unit and hold the reset until the logo appears. The unit will then proceed to boot into CoreELEC. First thing is to connect to WiFi, then enable SSH. This allows me to login via ssh and execute: ceemmc -x from the terminal. This writes CoreELEC to the built-in eMMC storage, after which I am able to remove the microSD card and reboot the unit into CoreELEC via the built-in sto...
Post a Comment
Read more